Application: Humidty,Cooling and Dust Control
Spray Pattern:Full Cone and Flat Fan type
Air Atomizing Nozzle
1.Application: Humidty, Cooling and Dust Control
2.Spray Pattern:Full Cone and Flat Fan
3.Adjustable: Sipone Type
4.Air Atomizing Nozzle:Siphon-fed Round
5.Siphon-fed Round type: Internal Mix, Full Cone, Adjustable, Air atomizing, Mixing Air and Water
6.Pressure-fed type: Internal Mix, Flat Fan Nozzles, Air Atomizing Spray Nozzles,Mixed Air Atomizing Nozzles and Adjustable
7.Material: 316 Stainless Steel, PP, PVC, Telflon,Brass
Mixed Air Atomizing Nozzles,
Adjustable and fixed air atomizing nozzle,
Air atomizing Air Atomizing Nozzle, Air Atomizing Nozzles, Mixed Atomizing Nozzle, Misting
Lowest flow available
Very fine atomization
Narrow spray angle (12° to 22°)
Full cone pattern
Short to moderate forward spray projection
D Atomizing Nozzle has special interior structure, which can evenly mix liquid & gas and generate tiny spraying drop or large spraying drop. In common situation, we can get super tiny (about 30mm) liquid spraying drop by air pressure increasing or hydraulic pressure decreasing.Adjustable Atomized can adjust liquid capacity. It can meet the requirement of spraying without changing air pressure and hydraulic pressure. Therefore, it has good adaptability. Each spray device is composed of air cap and liquid cap, which can offer two spray modes, flat fan and round, with wide liquid capacity coverage.Various available sizes of inlet joint for spray nozzle. It is flexible with changeable parts.Atomizing Nozzle has good moisture effect. It is the ideal choice for the location where requires moisture control.
If you applicance requiires flat fan spray air atomizing nozzles , youll find information on the large selection in the industry available in this section. Choose from dozens of nozzle bodies, assemblies and spray set-ups to get the precies performance you require.
Air atomizing nozzles require a single air source for the atomizing air. Some versions ,equipted with a cylinder for atomatic operation or clean-out and shut off needles ,may require an additional air line , Fluid lines are required for all moudels, The fluid line can be pressurized or supplied using a siphon-or gravity-fed configuration. It is recommended that air and fluid lines are equipped with the proper filters , reguators and valves .
Air atomizing nozzles require spray set-ups. Each set-up consists of an air cap and fluid cap ang some may also include O-rings and retainer caps, You can select from a wide assortment of capacities , spray patterns and pressure or siphon-fed set-ups.
Please contact us to assist you in selecting the suitable nozzle model for your application.